Description

Heavy Duty 4 PIN CCD Car Reversing Camera

and 20M Cable

HEAVY DUTY CCD REAR VIEW CAMERA

CCD colour camera
Strong metal casing
120° wide angle
Night vision, 18 infrared LED’s, see up to 10m distance
Rain/Sun protection hard metal hood

TV system	PAL NTSC
Specifications:
Sensor	Sharp 1/4” CCD image Sensor
Effective pixels	512(H) x 582 Pixels 512*492 Pixels
Resolution	480 TV lines
Sync system	Internal
Sensing System	2.1 Interface
Minimum illumination	0.2Lux/F 1.8 (0 Lux With LED on)
IR switch state	<10 Lux CDS on
IR switch control	CDS Automatic control
S/N Ratio	More then 48db
Video output	1.0 Vp-p,75ohm
Electronic shutter time	Auto PAL: 1/60-1/15000sec
Operation temperature	-20°C ~ 75˚C ( RH 95% Max)
Storage temperature	-30˚C ~ 85˚C (RH 95% Max)
Lens	2.8mm/120deg
Gain control	Automatic
White balance	Automatic
Current Consumption	No more then 300 mA
Power Supply	12V/24V
Function	With night vision
Waterproof	IP 67-IP68
Weight	300g
Dimension	77MM(W) x 55MM(D) x 90MM(H)

Featuring a full colour Heavy Duty steel case colour CCD Camera, suitable for any vehicle, especially Buses and Commercial Trucks where reversing blind spots are a problem, waste management trucks to monitor hopper area, School Buses to monitor back and side passage ways, Animal Transportation to keep an eye on livestock, Camper Vans and Caravans.

Please Note:

Not all 4PIN configurations are the same, our system uses a pin configuration as illustrated below. Our cameras have a MALE 4PIN connector, so you will need a FEMALE connector lead to your monitor, also you will need to make sure your current system has the same video and audio and power pins as this system has. Please ensure this camera is right for you before you buy it

Special Features

1. Complete solution deals with both power and singal transmission. No power cable is needed to connect camera.

2. Please pay attention to the diameter of the plug to ensure it is compatible with your cable.

Camera comes with female connector only, the extention cable is NOT included.